[AT] Air lines for shop

[Mark Greer]

Here is some info about Schedule 40 pipe.
https://www.engineeringtoolbox.com/wrought-steel-pipe-bursting-pressure-d_1123.html


On Fri, Sep 10, 2021 at 9:43 PM Spencer Yost <spencer at rdfarms.com> wrote:

> So I’m going to be making three new pipe runs from my air compressor.
> Previously I’ve just relied on hoses since the 50 foot hose will reach
> everywhere in my shop.
>
> It will consist of one long “trunk” run that will be nearly 40 feet, and
> then a few stub runs of anywhere from 5’ to 15’
>
> I was thinking about black pipe as that’s what I have used before. But I
> had no idea the common, affordable black pipe you find in hardware stores
> is only good to 150 psi. My compressor is two stage and is 175 psi:
>
> 3/4-in x 3-ft 150-PSI Black Iron Pipe
> https://www.lowes.com/pd/Southland-Pipe-3-4-in-x-3-ft-150-PSI-Black-Iron-Pipe/3371442
>
> I guess I’m thinking about biting the bullet and going copper. I’d like to
> go with some of those really neat new aluminum systems but I could never
> afford that.
>
> What are y’all think about copper? I know 3/4” copper is good to about
> 1000 psi.   It eliminates  the rust problem that eventually befalls all
> black steel pipe systems; which is kind of a plus.  As far as installation,
> I solder better than I cut threads :-)
>
>
>
> Spencer
>
>
> Sent from my iPhone
> _______________________________________________
> AT mailing list
> AT at lists.antique-tractor.com
> http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.antique-tractor.com/pipermail/at-antique-tractor.com/attachments/20210920/93c96b99/attachment.htm>