[AT] Removing clips

[Mattias Kessén]

I don't know, I've never seen it.

Den tors 13 maj 2021 18:26Spencer Yost <spencer at rdfarms.com> skrev:

> I replaced a bent pto shaft on an implement a few weeks ago.   I had to
> remove the two outer clips and press it out. I put it back together in a
> hurry and I decided to reuse the clips. Bad choice. During tedding a clip
> came off and the cross lost its cups and needle bearings.
>
>
>
> So I am replacing with a new cross kit and most notably, I have a clip to
> remove now.  I just remember the first time it was a real bugger because
> these clips don’t have holes in them. I can’t remember how I eventually did
> it (I think I finally was able to anchor one side and get a cotter pin
> remover under the other side) but I used cuss words I haven’t used in a
> long time and spent way more time than I am willing to spend this time.
>
> So I thought I’d ask for advice.
>
> How do you folks remove these? (Pic below)  I’ve searched all over the
> Internet but everyone’s got those clips with the ears or clips with holes
> in them in all the videos I’ve seen. I’ve seen a few mentions on forums but
> they all do things like drill behind it so you can stick a nail in and push
> it and other stuff like that.
>
> Thanks in advance!
>
>
>
> Sent from my iPhone_______________________________________________
> AT mailing list
> AT at lists.antique-tractor.com
> http://lists.antique-tractor.com/listinfo.cgi/at-antique-tractor.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.antique-tractor.com/pipermail/at-antique-tractor.com/attachments/20210513/024041da/attachment.htm>