[AT] Haywagon update

[Spencer Yost]

Had to be home today for a personal errand , so I had a chance to try to separate the Haywagon. Chained the rear to a tree and pulled.  Even with penetrant soaking for a few days after cutting a groove in the tube, a bobcat could not pull  that thing apart.  So I tried twisting by picking up one front tire with the bobcat bucket and it did create a twist. So I set it back down and pushed to twist it back. Try pulling again and it still wouldn't separate.   So I picked up  the other front tire and got it to twist. Set it back down. This time it pulled apart ever so slowly but it finally came.

 I am so glad I didn't bother with any other method and went straight to Cecil's solution of cutting a slot in the tube.  After heating grooving, soaking, twisting it still took a bobcat to pull it apart.  I think that thing was close to rust welding itself.

Here's a picture of the groove in the picture of rust on the inner tube.

Next will come welding. I guess I'll  have to be careful not to weld the innertube to the outer tube :-). I'm afraid to weld it without the inner tube in place because if I get some slag/welding material below the groove i will have a hard time grinding  it out so that the innertube can slide in.

-------------- next part --------------
A non-text attachment was scrubbed...
Name: image1.JPG
Type: image/jpeg
Size: 132640 bytes
Desc: not available
URL: <http://lists.antique-tractor.com/pipermail/at-antique-tractor.com/attachments/20180222/a3d1c880/attachment.jpe>
-------------- next part --------------

-------------- next part --------------
A non-text attachment was scrubbed...
Name: image2.JPG
Type: image/jpeg
Size: 145149 bytes
Desc: not available
URL: <http://lists.antique-tractor.com/pipermail/at-antique-tractor.com/attachments/20180222/a3d1c880/attachment-0001.jpe>
-------------- next part --------------

Spencer Yost