[AT] 430V update

[Dean VP]

Spencer,
One of the more important things I have learned way to late in messing with these old tractors is to not try to remove manifolds unless I absolutely have to. I don't like drilling out broken off manifold bolts and that is almost guaranteed on 50 plus year old tractors. I agree with Steve that your idling issues are more than likely worn carburetor shaft issues OR incorrectly adjusted linkage. Since you needed to mess with the throttle you might start with that adjustment. I've had more idling problems caused by linkage issues that I want to talk about because I never check that first.  Spray a little WD40, using the straw, at the shaft entrances to the carburetor body. Changing a carburetor shaft is no big deal. I don't remember if the 430 has bushings for the shaft or not. I doubt it.  The shaft is just probably made of a softer material.  The carburetor for the 430V should be a TSX 688. JD had a series of carburetors for the 420 from TSX 641 to 678 to 688 to 689 but the 430 Gas S/B TSX 688. The AF 430 would be a 678 or 689

      From: Spencer Yost <yostsw at atis.net>
 To: at at lists.antique-tractor.com 
 Sent: Friday, November 17, 2017 9:47 PM
 Subject: [AT] 430V update
   
I tried several things to find the vacuum leak, and the problem is either not a vacuum leak, or is just so insidious that propane and WD-40 just simply isn't going to find it. Considering manifold gaskets are super easy to replace and cheap, I just ordered a replacement gasket(carb and manifold) from John Deere(price was competitive).  At least I can rule out the gaskets after I deck/file the manifold and replace the gaskets.

I am beginning to suspect the Carb. I didn't have a hunt at idle for the first little bit that I ran the engine. But the throttle also wasn't working so I never got a true idle so I assumed the hunt was real and the lack of throttle control hid it.  Plus I am not getting the response from adjustments that I would expect.  

Also, I am pretty sure the carburetor is a MS TSX 541. The parts catalog indicates  I should have a 641. I need to pull the carb  when I do the manifold and double check the number. (Of course the tag is facing the engine so I can't see it).  Does anyone know if the 641s were a definite for this tractor? The 541s were common on Ford's, so I'm afraid the carb is been replaced sometime in the past. If that's the case that might explain my hunt.

I got the serial number research from the two cylinder club today. Here's a picture of the document they sent me. The tractor survives as it was shipped a except the "dry charge" battery of course (-:  Everything mentioned is still the same and the tail light even still works(did have to clean up the ground).

An interesting sidenote: the finish date is my wife's birthday(it is a few years older). I thought that would earn a few points for the tractor, but I don't think it did :-)




Spencer Yost_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at