[AT] hole saw

[Len Rugen]

If you're cutting holes the sizes used in instrument panels, they make tools for that, like the link below.  The metal shop where I went to college used theirs a lot, but I don't think it ever needed sharpening.  There is another kind that "punches" instead of cuts, but the one I saw was for smaller holes.  I went to the College of the Ozarks and worked as a mechanic.  We had lots of surplus equipment, old equipment and would re-fab things.   We turned Buda tugs into "Engines" for tour trains with a faux steam appearing skin.  The rear fenders and body was all cast iron, about 4" thick, just for ballast.  They would pull :-)
Greenlee Hole Cutter Kit, 9 PC 930 | Zoro.com
  
|  
|   
|   
|   $ 209.21   |    |

   |

  |
|  
|   |  
Greenlee Hole Cutter Kit, 9 PC 930 | Zoro.com
 Order GREENLEE Hole Cutter Kit, 9 PC, 930 at Zoro.com. Great prices & free shipping on orders over $50!  |   |

  |

  |

 


 

Len Rugen

rugenl at yahoo.com


 

    On Tuesday, May 30, 2017 5:52 PM, Richard Fink Sr <rfinksr at verizon.net> wrote:
 

 Hi board of knowledge, does any one know if metal cutting hole saws can 
be sharpened, tractor reference used to make tractor parts, if so can 
you send me a link where i may get them done,then will know if cheaper 
to buy new. our local hardware that done blades and the like was sold 
new owner don,t know how or if he can don,t know how to operate 
equipment.????

Thanks

R Fink Sr

PA


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at