[AT] sharp turns with a baler

[charlie hill]

Glad you got it figured out John!

Charlie

-----Original Message----- 
From: John Hall 
Sent: Thursday, June 29, 2017 8:46 AM 
To: Antique tractor email discussion group 
Subject: [AT] sharp turns with a baler 

Just an update to a question last year. The 276 New Holland baler I 
picked up last year did not like much turning with the PTO running, I 
had to throw it out of gear in some fields to turn around. Turns out the 
piece on the baler that the drive shaft bolts to had severely worn 
bushings. This is the piece that has the pawls mounted in it so when the 
PTO stops, the baler can coast to a stop. I dressed up the pawls a bit 
too, as they were not engaging as clean as they should. Now I can turn 
as short as the driveshaft itself will allow while spinning.

John Hall


_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at