[AT] Farmall distributors

[Stephen Offiler]

I haven't used a Pertronix ignition myself, but they do have a good
reputation (here on ATIS and elsewhere).  They have several products, most
designed for newer equipment and performance/race applications.  Per their
website, the original "Ignitor" is the one for old tractors, with some 6V
pos or neg ground models available.

http://www.pertronix.com/prod/ig/ignitor/default.aspx

A magnet unit slides onto the distributor shaft under the rotor, and the
points are replaced by a little black box containing a device that senses
when the magnet goes by.  It will probably work pretty well even if the gap
between the magnet and black box varies due to slop in the shaft.  Up to
the point where the magnet physically contacts the black box, I suppose.

It appears that you locate the correct kit by entering the model number of
your distributor, or, you call them the old-fashioned way.

I'm thinking about one of these for my JD440IC, but haven't pulled the
trigger yet (just a round tuit thing).  When several months go by without
firing it up, I always need to clean the points before it will run.

SO




On Sat, Dec 16, 2017 at 12:16 AM, Darrell Ratliff <dbigdog at columbus.rr.com>
wrote:

> They do have 6 volt Pertronix units but since the Pertronix uses the
> distributor shaft I think the existing play in the shaft would give the
> same problem
>
> From: John Hall
> Sent: Friday, December 15, 2017 8:24 PM
> To: Antique tractor email discussion group
> Subject: Re: [AT] Farmall distributors
>
> Don't know anything about the conversion, do they work with 6 volt
> systems? I've got a LOT of mechanical wear in these distributors.
>
> John
>
>
> On 12/14/2017 9:50 PM, Mike M wrote:
> > Would converting to the Pertronix system work in it's place?
> >
> > Mike M
> >
> >
> > On 12/14/2017 7:59 PM, John Hall wrote:
> >>     Got a couple Super A Farmalls with worn out distributors. I put a
> set
> >> of points in one last spring and it was almost impossible to get them
> >> set as the shaft has a ton of slop in it. I see there are a few
> >> aftermarket parts for these, so this must be a common problem. To be
> >> honest, I have never had to do anything to a distributor other than tune
> >> up items. I'm assuming there are some bushings, and maybe a shaft that
> >> need replacing. Anything in particular I should really look for? Not
> >> wanting to make them factory perfect as we don't use them enough to
> >> warrant that extensive of repair. But if I can wind the clock back 30-40
> >> years, well that's an acceptable amount of wear I can live with. Any
> >> advice is appreciated, probably won't get into them until first of the
> year.
> >>
> >> John Hall
> >>
> >> _______________________________________________
> >> AT mailing list
> >> http://www.antique-tractor.com/mailman/listinfo/at
> >>
> >
> > ---
> > This email has been checked for viruses by Avast antivirus software.
> > https://www.avast.com/antivirus
> >
> > _______________________________________________
> > AT mailing list
> > http://www.antique-tractor.com/mailman/listinfo/at
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>