[AT] Ingersoll Compressor followed me home

[charlie hill]

Cecil.  You say it is holding 180 psi right now but at how much flow?
I agree you probably need to back it down a bit but it needs to hold
the 100 psi at 250 cu. ft. per minute flow.

Charlie

-----Original Message----- 
From: Cecil Bearden 
Sent: Thursday, May 12, 2016 10:16 PM 
To: Antique tractor email discussion group 
Subject: Re: [AT] Ingersoll Compressor followed me home 

An Ingersoll DR250 Gyro Flo came home today.   It has a 4-53 Detroit 
engine and a 250 CFM 2 Stage Vane type compressor.  At this time it is 
operating at 180 PSI.  The serial number plate states 100PSIG operating 
pressure.   I am going to make some adjustments to lower the pressure.  
However, if it will make this much pressure, it should be in good 
condition.   The engine starts right up without ether, so it appears to 
be alright also.   It was a former OK Highway department unit...
Anyone have any experience or info on one of these..??

Cecil in OKla
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at


_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at