[AT] Allis Chalmers

[Cecil Bearden]

I have been using the old AC 7030 pulling the 1340 Hesston Rotary 
swather.  It pulls it great. however, when the oil gets hot, it takes a 
while in high gear to get the clutch to engage.   I don't know if it is 
adjustment or it needs a few clutch piston rings.  I would have to dig 
out 3 cans of foam insulation to find the adjustment.  I had to use the 
foam and an old Mud Flap to stop the engine heat from coming up through 
the dash.  It was like a hair dryer.  The Air cond will coll the cab 
down to about 85 degrees, so its a lot better than no cab and much 
better than a cab without air...
Those old 7030's were good tractors.,  Allis made some good tractors, 
but their engineers must have been anorexic.. I have to take the 
steering wheel off to get into the cab and in the seat.
Cecil in OKla




On 6/10/2016 3:43 PM, Grant Brians wrote:
> Hmm, it could not be that you are still an Allis fan could it??? LOL. By
> the way the Spray rig looks like we will have it back together today in
> time to test and then spray tomorrow.
>                  Grant Brians
> On 6/10/2016 8:42 AM, Recentjester at aol.com wrote:
>> I like Orange stories
>>    
>>    
>> In a message dated 6/10/2016 9:52:54 A.M. Central Daylight Time,
>> yostsw at atis.net writes:
>>
>> I love  the "going and getting" stories.  BTW I drive one of those once. -
>> a heck  of a tractor.  You got a deal!
>>
>> Spencer Yost
>>
>>> On Jun 10,  2016, at 9:38 AM, Grant Brians <sales at heirloom-organic.com>
>> wrote:
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at