[AT] Allis Chalmers

[charlie hill]

Cecil, is it the engine clutch or the power director clutch that is not 
engaging?

Charlie

-----Original Message----- 
From: Cecil Bearden
Sent: Saturday, June 11, 2016 12:07 AM
To: Antique tractor email discussion group
Subject: Re: [AT] Allis Chalmers

I have been using the old AC 7030 pulling the 1340 Hesston Rotary
swather.  It pulls it great. however, when the oil gets hot, it takes a
while in high gear to get the clutch to engage.   I don't know if it is
adjustment or it needs a few clutch piston rings.  I would have to dig
out 3 cans of foam insulation to find the adjustment.  I had to use the
foam and an old Mud Flap to stop the engine heat from coming up through
the dash.  It was like a hair dryer.  The Air cond will coll the cab
down to about 85 degrees, so its a lot better than no cab and much
better than a cab without air...
Those old 7030's were good tractors.,  Allis made some good tractors,
but their engineers must have been anorexic.. I have to take the
steering wheel off to get into the cab and in the seat.
Cecil in OKla




On 6/10/2016 3:43 PM, Grant Brians wrote:
> Hmm, it could not be that you are still an Allis fan could it??? LOL. By
> the way the Spray rig looks like we will have it back together today in
> time to test and then spray tomorrow.
>                  Grant Brians
> On 6/10/2016 8:42 AM, Recentjester at aol.com wrote:
>> I like Orange stories
>>
>>
>> In a message dated 6/10/2016 9:52:54 A.M. Central Daylight Time,
>> yostsw at atis.net writes:
>>
>> I love  the "going and getting" stories.  BTW I drive one of those 
>> once. -
>> a heck  of a tractor.  You got a deal!
>>
>> Spencer Yost
>>
>>> On Jun 10,  2016, at 9:38 AM, Grant Brians <sales at heirloom-organic.com>
>> wrote:
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at


_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at