[AT] Chrysler to SAE bell housing adapters

[Cecil R Bearden]

On 1/28/2016 5:54 PM, Steve W. wrote:
> Cecil R Bearden wrote:
>> I have decided to do something to the underpowered 2.3L in my sullair
>> compressor I use to blow off and sandblast my tractors and equipment.
>> The 2.3L was underpowered to start with.  I got the info from a Ford
>> industrial parts person with 35 yrs experience.   I have a slant 6-225
>> from an irrigation well on propane, and also a 460 Chrysler v-8 on
>> propane from a well.   I am looking for an adapter from the chrysler to
>> the SAE bell housing I don't know for sure what the bell housing number
>> is but there are adapters between the SAE numbers, I think I need a #3
>> or #4.  I have found soem GM ones, but not chrysler.....
>>
>> Cecil in oKla
>> _______________________________________________
>> AT mailing list
>> http://www.antique-tractor.com/mailman/listinfo/at
>
>
> http://www.phxgrp.com/transChrysler.htm
>
> 460 or 360 Chrysler?
>
> Now if that truly is an M-460 Chrysler you have then you might need to
> look close at it. Those were actually Ford 460's that Chrysler bought to
> fill a gap in their engine line. It could have either bolt pattern on it.
>
I think it is a 440 industrial.   I really do not want to use it for 
this compressor.  Running at 2300 Rpm, it would probably use some fuel.

Ceci in OKla