[AT] OT Engine Swap on air compressor

Steve W. swilliams268 at frontier.com
Sat Jan 23 22:23:45 PST 2016


Cecil R Bearden wrote:
> I attached a copy of the parts diagram for the sullair.
> 
> Cecil in OKla
> 

Looks like you could easily convert it. The adapter plate thickness can 
be made up using a ring of aluminum the same thickness as the plate 
between part 27 and the flywheel.

 From that diagram it looks like you could basically pick any engine 
that would fit in place of the 2.3. Just make an adapter plate to hold 
it centered on the air pump drive.

Another possibility would be to add a clutch in there. Replace the 
entire coupler assembly. From the diagram it looks like they use a 
standard flywheel on the engine. Part 27 bolts into the holes that a 
pressure plate normally goes. Part 25 bolts to part 22 and takes the 
place of a clutch plate.

You might just take a look and see if a pinto clutch would fit in there, 
you might need to make a hub adapter to make the splines work and use a 
hydraulic throw out bearing. Might be easier to get it up and running.


-- 
Steve W.



More information about the AT mailing list