[AT] Allis Chalmers B Main bearings .040

[Recentjester at aol.com]

I did leave a post on that site Charlie still waiting for a  bite. thanks 
for your concern.
 
 
In a message dated 10/31/2015 7:09:36 P.M. Central Daylight Time,  
charliehill at embarqmail.com writes:

Go over  to the WWW.Allischalmers.com.  Go to the discussion page and
talk to  the guys there.  There are dozens of guys on that site that speak
only  Allis Chalmers and many of them are former dealers or  dealership
mechanics.  There is also a fair group of parts vendors  hanging around on
the site and all of the ones I've dealt with are straight  up honest and
very helpful.

Charlie

-----Original  Message----- 
From: Recentjester at aol.com
Sent: Saturday, October 31,  2015 2:52 PM
To: at at lists.antique-tractor.com
Subject: [AT] Allis  Chalmers B Main bearings .040


I have finally found the time to  start putting my 39 Allis back  together.
Made the shims and finished  shimming the rod bearings with the pistons  off
and while the crank  was in the lathe. time consuming but that was done. The
unpacked the mains  an they are not even for this tractor. the crank was
ground  to  2'.010. They are hard find 10 to 30 all over the place even 
.060  
is
available. May try an get them to weld it up. This is going to make  more
time  than I thought. Any one know of any would appreciate   it.
_______________________________________________
AT mailing  list
http://www.antique-tractor.com/mailman/listinfo/at  

_______________________________________________
AT mailing  list
http://www.antique-tractor.com/mailman/listinfo/at