[AT] Allis Chalmers B Main bearings .040

charlie hill charliehill at embarqmail.com
Sat Oct 31 17:04:30 PDT 2015


Go over to the WWW.Allischalmers.com.  Go to the discussion page and
talk to the guys there.  There are dozens of guys on that site that speak
only Allis Chalmers and many of them are former dealers or dealership
mechanics.  There is also a fair group of parts vendors hanging around on
the site and all of the ones I've dealt with are straight up honest and
very helpful.

Charlie

-----Original Message----- 
From: Recentjester at aol.com
Sent: Saturday, October 31, 2015 2:52 PM
To: at at lists.antique-tractor.com
Subject: [AT] Allis Chalmers B Main bearings .040


I have finally found the time to start putting my 39 Allis back  together.
Made the shims and finished shimming the rod bearings with the pistons  off
and while the crank was in the lathe. time consuming but that was done. The
unpacked the mains an they are not even for this tractor. the crank was
ground  to 2'.010. They are hard find 10 to 30 all over the place even .060 
is
available. May try an get them to weld it up. This is going to make more
time  than I thought. Any one know of any would appreciate  it.
_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at 




More information about the AT mailing list