[AT] Allis Chalmers B Main bearings .040

[Recentjester at aol.com]

I have finally found the time to start putting my 39 Allis back  together. 
Made the shims and finished shimming the rod bearings with the pistons  off 
and while the crank was in the lathe. time consuming but that was done. The  
unpacked the mains an they are not even for this tractor. the crank was 
ground  to 2'.010. They are hard find 10 to 30 all over the place even .060 is  
available. May try an get them to weld it up. This is going to make more 
time  than I thought. Any one know of any would appreciate  it.