[Farmall] H water pump pulley

[Barney Van De Weert]

Not a roll pin, but a solid pin that had a v grove pressed into the side of it to expand it so it would stay in the hole, and yes they would be blind holes. It would probably have to be drilled out to remove it. Barney Van De Weert
      From: "jtchall at nc.rr.com" <jtchall at nc.rr.com>
 To: Farmall/IHC mailing list <farmall at lists.antique-tractor.com> 
 Sent: Monday, February 23, 2015 8:50 PM
 Subject: Re: [Farmall] H water pump pulley
   
You mean a roll pin? According to what the guy told my dad, the hole doesn't 
go through, its blind. I'd love to have seen it.

John

-----Original Message----- 
From: Barney Van De Weert
Sent: Monday, February 23, 2015 9:26 PM
To: Farmall/IHC mailing list
Subject: Re: [Farmall] H water pump pulley

I vaguely remember IH using a pin that had a slot on the side to hold stuff 
together back then-  Barney Van De Weert
      From: "jtchall at nc.rr.com" <jtchall at nc.rr.com>
To: farmall <farmall at lists.antique-tractor.com>
Sent: Monday, February 23, 2015 7:37 PM
Subject: [Farmall] H water pump pulley

Dad got a call today wanting to now how to get the back half of the pulley 
off of an H water pump, guy said it had some sort of pin in it that didn’t 
appear to go through. Dad doesn’t remember and I’ve never worked on one. My 
only thought was it’s a taper pin, but I’ve never seen those used anywhere 
other than the gearbox on a lathe. Anybody know how it comes apart?

John Hall
_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall



_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall 




_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall