[AT] here I go again

[charlie hill]

Might be time to check some serial numbers and casting numbers
and make sure it is a Super A and not an A with Super A decals.
Or is it possible that a used rear casting from an A has been
used to replace the Super A rear casting.

Charlie

-----Original Message----- 
From: jtchall at nc.rr.com
Sent: Monday, July 28, 2014 9:53 PM
To: Antique tractor email discussion group
Subject: Re: [AT] here I go again

Ron, not that it matters much but I ran the sizes by dad. He couldn't recall
any of the Super A's with a small PTO shaft. He thinks the straight A did,
possibly they would interchange? If what you have ordered doesn't fix the
problem, we better look at some parts books.

John


-----Original Message----- 
From: jtchall at nc.rr.com
Sent: Monday, July 28, 2014 6:38 PM
To: Antique tractor email discussion group
Subject: Re: [AT] here I go again

Took a quick glance at the parts book, didn't see a small one listed, just
the 1 3/8. I'm headed over to the shop now, I'll ask dad if there were 2
sizes available or if the shaft in yours is out of something else, maybe a
straight A? did you wind up getting another shaft or are you going to use an
adpator?

John


-----Original Message----- 
From: Ron Cook
Sent: Sunday, July 27, 2014 10:07 PM
To: Antique tractor email discussion group
Subject: Re: [AT] here I go again

John,
     The pto shaft is 6 spline 1 1/8 diameter.  I need 6 spline 1 3/8
diameter.  I found a source.
     I'll be sure to watch the clearance to the oil pan.  Thanks for
that warning.

Ron Cook
Salix, IA


_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at


_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at