[AT] here I go again

[jtchall at nc.rr.com]

Took a quick glance at the parts book, didn't see a small one listed, just 
the 1 3/8. I'm headed over to the shop now, I'll ask dad if there were 2 
sizes available or if the shaft in yours is out of something else, maybe a 
straight A? did you wind up getting another shaft or are you going to use an 
adpator?

John


-----Original Message----- 
From: Ron Cook
Sent: Sunday, July 27, 2014 10:07 PM
To: Antique tractor email discussion group
Subject: Re: [AT] here I go again

John,
     The pto shaft is 6 spline 1 1/8 diameter.  I need 6 spline 1 3/8
diameter.  I found a source.
     I'll be sure to watch the clearance to the oil pan.  Thanks for
that warning.

Ron Cook
Salix, IA