[AT] Drill bits

Carl Gogol cgogol at twcny.rr.com
Mon Oct 14 06:42:13 PDT 2013


I have a Drill Doctor about 5 years old and like it except I can never 
remember to change the angle setting to the drill I have in hand.  So it 
gets a new cutting angle or I have to do it again and it takes a lot more 
time since you do remove a lot more material in this two step process.  If I 
follow the directions the drills cut like new.
Through the years I have found a good sale for some of the important sizes 
of drills in Cobalt and buy a batch of 10 or 20 - you just can't beat the 
performance of Cobalt on steel.  The DD will sharpen these but you must 
remember to use the right angle - for sure.
Carl

-----Original Message----- 
From: Spencer Yost
Sent: Monday, October 14, 2013 8:50 AM
To: Antique tractor email discussion group
Subject: Re: [AT] Drill bits

I use a drill doctor and like it.  I have mixed success free-handing.   When 
I free-hand they are sharper than before, but not like new.   With the drill 
doctor they are like new.    I will be the first to admit that I am a bad 
hand sharpener and others(maybe you also) might get great results free 
handing.

Size is a problem with the drill doctor.  Each model sharpens certain sizes. 
So the occasional large bit still has to be sharpened by hand unless you get 
the top-of-line model or an optional chuck.    In addition, wood boring 
spade bits cannot be done by any model except one.  And that model cannot do 
large twist bits I fi remember right.  I am sure they have a web site that 
can help you choose though.

Hope this helps,

Spencer

Sent from my iPhone

> On Oct 13, 2013, at 23:07, "Dick Day" <ddss at telebeep.com> wrote:
>
> I guarantee that everyone on this list knows way more than I do about 
> tools.
> I assume that, like most things, you get what you pay for.  Years ago, I
> bought what I thought was a very good (expensive, at least for this 
> wallet)
> set of drill bits, that went from just thicker than a hair to 1/2"  They
> performed well but over the years they have pretty much worn out, and I 
> hate
> to admit it, I broke a few and lost one.  When drilling any type of metal, 
> I
> always have a can of 3-in-1 Oil with me and use it liberally.
>
> Does anyone use a Drill Doctor (or similar piece of equipment) to lengthen
> the life of your bits?  It looks like they range in cost from $50 to $250.
> Before I invest in a new set of bits, any thoughts on renewing verses
> replacing?
>
> Thanks
>
> Dick
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at 




More information about the AT mailing list