[AT] OT - Question about chain

Cecil R Bearden crbearden at copper.net
Tue Nov 26 15:18:05 PST 2013


5/16 grade 70 is the smallest I use around here.  I keep my lifting 
chains and my pulling chains separate.  I will not use a chain that has 
been used for pulling to lift or tie down machinery.  I have seen too 
many accidents from chains with bad links.  If at all possible I only 
lift with a grade 70 chain.  Winching a piece of equipment on  a truck 
or trailer is the same as pulling.   There may be a disaster if the 
chain breaks.  Inspect your chain every time you use it.  If it has a 
bent link or a pulled hook, don't use it until it is fixed, and then 
only use it for pulling.  I do not trust nylon straps for pulling.  I 
lost  the end of my thumb from a nylon rope on a horse lead.  Nylon 
straps are like rubber bands.

Just my $0.02

Cecil in OKla


On 11/26/2013 12:59 PM, Mike wrote:
> Hi guys, I need to upgrade the rag tag bunch of chains I have around the
> place and I'm looking for some input.  I generally use the chains to
> pull on trees that are hung up on others and to dangerous for me to cut.
> I have some 1/4 grade 30 chain  that I have pulled on hard enough to
> deform, and some 5/16" grade 30 that has held up well, but I only have a
> short piece of that. I'm looking at 1/4" grade 43 high test that has a
> working strength of 2600 lbs twice the 1/4 grade 30. I use either my
> Massey 255 or my pickup depending where the tree is.  Do you guys think
> the 1/4" grade 43 is enough or should I bump up to 5/16" $$. Any input
> would be appreciated.
> Thanks,
> Mike M
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at




More information about the AT mailing list