[AT] John Deere 4200 compact tractor power steering Alert

[charlie hill]

That would make sense Larry.  I can't imagine a company of the size and
stature of Deere allowing a known defect of such importance to go 
unaddressed.

Charlie

-----Original Message----- 
From: Larry Goss
Sent: Friday, May 31, 2013 12:39 PM
To: Antique tractor email discussion group
Subject: Re: [AT] John Deere 4200 compact tractor power steering Alert

Alan, I would suspect that someone broke the seal on the tractor that's 
being discussed here, and didn't bother reassembling it correctly. The 
description of a strictly hydraulic steering system is pretty typical of 
modern compact tractors. I own three of them (all different brands) and none 
has a mechanical link between the steering wheel and the steering bell 
crank.

Larry

----- Original Message -----
From: Alan Nadeau <ajnadeau1 at myfairpoint.net>
To: Antique tractor email discussion group <at at lists.antique-tractor.com>
Sent: Fri, 31 May 2013 12:21:34 -0400 (EDT)
Subject: Re: [AT] John Deere 4200 compact tractor power steering Alert

I have repaired quite a few of the welded cylinders.  While not easily
repairable they are relatively easy to take apart.  Every one I have had
apart had the piston bolt VERY firmly secured with Loctite or similar
retaining compound.   If done properly, and the ones I have seen have been,
it is sometimes impossible to get the piston bolt out without heating it to
break the locking compound loose.


----- Original Message ----- 
From: "Ernst Borchert" <eb3 at shelby.net>
To: "'Antique tractor email discussion group'"
<at at lists.antique-tractor.com>
Sent: Friday, May 31, 2013 7:59 AM
Subject: [AT] John Deere 4200 compact tractor power steering Alert


> My neighbor has a 2000 John Deere 4200 tractor with loader. The other day
> while driving it on 226 in W.NC the steering quit and turned the wheels
> completely to the left and sent him across the highway into the other side
> of the road. It was lucky that no traffic was coming and there was no
> ditch
> on the side of the road. The steering on these tractors have no mechanical
> connection between the steering wheel and the front wheels, but are
> controlled by hydraulic pressure diverted to a cylinder connected to the
> front wheels. The bolt that holds the piston to the rod in the cylinder
> came
> unscrewed due to vibration, thus forcing the wheels to the left. The
> cylinder is of welded construction so you can not check the tightness of
> the
> bolt and you can not repair the cylinder. The replacement cylinder is
> repairable. The thing is that if the cylinder fails at road speed or in a
> difficult situation the results can be fatal. Be careful out there,
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at