[AT] IH 350 U RUNS now hydraulic problem

[toma at risingnet.net]

Quoting Ron Cook <ron at lakeport-1.com>:

> Tom,
>      Yes.  There is a shaft inside that tube with an end that engages
> the throttle shaft on the carburetor.  It is not fastened, it slides
> off.  No problem.  Just like an H.


I got the carb off and back on. It is a little tricky getting that  
tang lined up but I got it. I guess it is a good system, it keeps the  
linkage from wearing. The carb had a mud dauber nest in it. That  
happened since I have had it. I could not find how come it was  
leaking. It has a gubber tipped needle in it so I could not re seat it  
but it is not leaking now so that is good.

I got it running, now I am back to where I was a few years ago.

Now I have the hydraulic problem. I am not getting any pressure to the  
power steering. I know there is a priority valve there somewhere, It  
may be stuck. I think it worked when I first got it. There was a  
broken gear tooth in the steering box. As I recall it would kind of  
steer. After I got it torn apart I realized the left side was steering  
with the box and the other side was steering with the power steering.  
I did not run it much because the gas tank was full of water and I was  
running it off a hose syphoning put of a gas can.

Now I cannot steer it at all without the power assist unless I lift  
the front wheels off the ground with the bucket. I have the books for  
it someplace.

Tom