[Farmall] Farmall H Vertical Distributor Problems/Parts

[Jerry Bossard]

Thanks Carl!  I appreciate the information.  I'll get started on it in a
couple of days.

Jerry


On Tue, Apr 23, 2013 at 8:41 AM, <szabelsk at gdls.com> wrote:

> Jerry,
>
> The process basically consists of lining up the timing marks on the gears,
> making sure the #1 cylinder is at TDC, setting the rotor at the #1 firing
> position, and sliding the unit in so that the #1 firing position is still
> lined up.  After it's installed you rotate the distributor left or right a
> little to compensate for anything being off before locking it down. The
> manuals usually have some decent instructions on how to do this, along
> with some decent pictures. It's not difficult to do, but can take some
> time if you haven't done it before. Worst case would be that you get the
> timing out of whack and have to start over again.
>
> Carl Szabelski
>
>
> The Borg Are Wrong, Resistance Is Not Futile ..... It's Voltage / Current
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
>