[AT] MF 135

Tom tmartin at xtra.co.nz
Sat Apr 6 16:46:39 PDT 2013


Can I ask why you didn't shim the rods to the crank while it was out?

Tom

--- On Sat, 6/4/13, drupert at seanet.com <drupert at seanet.com> wrote:


I too find shims guesswork and a pain.  I am currently in the process of
overhauling a 1952 JD Model B engine.  The crank has been reworked and is
back in and the Block has been bored 90 thousands. The Rods have been
checked, new Bushings installed and are now ready to be attach to the
Crank.  However, the Rod Bearings(Babbitt) are adjusted via shims and
therein is my excuse for procrastination.  I hate having to reach in the
small access hole to tighten a Rod only to learn that I have to loosen it
to add/substract shims and then drop some/all of the shims from one side
of the Rod into the bottom of the engine only to not be able to reach
under the Crank to retrieve all of those tiny brass shims.


Dudley

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at



More information about the AT mailing list