[AT] test

[Tyler Juranek]

Hi Mike, still here in Iowa, JD A and all.
Accept we have 2 JD A's. One doesn't run right, and the other one is a
pain in the ass to crank but runs really good!
Take care.

On 10/20/12, jtchall at nc.rr.com <jtchall at nc.rr.com> wrote:
> Still here Mike. Haven't seen any messages all week, I guess everyone is
> outside enjoying this nice fall weather.
>
> We've been turning wrenches on my 3300 Deere combine for over a month. Still
>
> a ways to go yet to get it field ready. I've put in 11 bearings, 5 idler
> pulleys, 3 bearing blocks, 9 or 10 belts, one auger, 4 seals, 4 headlights,
>
> 2 hydraulic hoses, repaired a bunch of wiring harness, and re-machined  3
> pivots for idlers that were beyond worn out. We are getting close to taking
>
> it for a test drive so I can check the brakes out ( pulled them apart to
> clean them and change the bearings, balls and springs). I still need to put
>
> a kit in the carb and then turn my attention to the header. Also going to
> install a battery disconnect switch---there are just way too many (old)
> wires on this machine for my liking. One thing I have discovered on this
> machine is that it appears the quality of farm equipment went down the tubes
>
> just like automobiles during the 1970's. This machine is a mixture of
> english and metric sizes, poor design, and even poor factory support (found
>
> a few errors in the parts books).
>
> John Hall
>
>
> -----Original Message-----
> From: Mike Meulenberg
> Sent: Saturday, October 20, 2012 8:13 PM
> To: at
> Subject: [AT] test
>
> Anyone home?
>
> Mike
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>


-- 
Check out my youtube channel, and spread the word!
http://www.youtube.com/tylerthetechy/