[AT] Shop question

[charlie hill]

Good idea Cecil!

Charlie

-----Original Message----- 
From: Cecil R Bearden
Sent: Wednesday, May 09, 2012 7:54 AM
To: Antique tractor email discussion group
Subject: Re: [AT] Shop question

Could you use a round floor plate flange with a close nipple on each
side of the metal.  If you were concerned about it scraping where it
went through the metal, you could put a piece of plastic pipe for a
bushing.  The floor plates will seal with silicone or a gasket.

Cecil in OKla


On 5/8/2012 2:11 PM, Dave Rotigel wrote:
> Duct seal will work well Len. See: 
> http://www.lowes.com/pd_13591-12704-31-601_0__?productId=3127723
> Dave
>
> On May 8, 2012, at 11:45 AM, Len Rugen wrote:
>
>> I need to run a 2" conduit LB box thru a metal shop wall.  How should I
>> seal around that to keep water&  bugs out?  Just silicone the back of
>> the LB to the metal?  The conduit will run down and I'll use straps and
>> roofing screws to attach that.  It won't be under an eave, so could get
>> some direct rain.
>>
>> Thanks.
>> _______________________________________________
>> AT mailing list
>> http://www.antique-tractor.com/mailman/listinfo/at
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at