[AT] Ford 5000 Hydraulic lift cylinder
charlie hill
charliehill at embarqmail.com
Tue May 1 04:25:34 PDT 2012
Cecil, is it cast or steel? Can you weld it or braze it or can you cut or
grind away the old broken part and weld a coupling to the housing? Not
being able to see it, I may be way out of the ballpark.
Charlie
-----Original Message-----
From: Cecil R Bearden
Sent: Tuesday, May 01, 2012 12:22 AM
To: Antique tractor email discussion group
Subject: Re: [AT] Ford 5000 Hydraulic lift cylinder
Anyone got a source for a hyd lift cylinder for a 5000 Ford w/o the load
monitor??
I pulled the top deck today to repair the PTO clutch and find out why
the lift would not lower. I followed the directions in the I&T shop
manual, and it stated to pull the hydraulic lift cover then remove the
pipe and filter to the hyd pump. The Hyd filter had a pipe that screws
into the side of the hyd lift cylinder. Where the pipe screws into the
cylinder is now broken in half. A replacement cylinder is about
$1500.00 !!!!! I was trying to get the tractor ready to take to a
auction sale. I really do not know if we broke it today or it has been
cracked for a long time and gave way a couple of years ago.
Anyway, I have to find a cylinder or maybe overbore the old hole, and
screw in a bushing, then rethread the bushing. I can do it, but it
would be much better done by an old machinist friend of mine.
Anyone have any experience?
Cecil in OKla
_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at
More information about the AT
mailing list