[Farmall] 1949H - Exhaust Pipe - Followup

[cliff king]

there is a way to make a thread chaser with a right angle grinder going parallel with the pipe.
 
C

--- On Thu, 6/7/12, Kevin Weinstock <knbshn at mosaicmobile.net> wrote:


From: Kevin Weinstock <knbshn at mosaicmobile.net>
Subject: Re: [Farmall] 1949H - Exhaust Pipe - Followup
To: "Farmall/IHC mailing list" <farmall at lists.antique-tractor.com>
Date: Thursday, June 7, 2012, 10:45 AM


Hey I just had a brain fart, you might consider drilling 1/2" holes through 
the side of that 2" x 6" nipple, maybe down near the "chaser" end of it. 
This could allow you to insert a hefty punch or whatever, to help work the 
nipple back and forth. This might be handier than trying to use a bulky pipe 
wrench. Just a thought. Good Luck ! Kevin
----- Original Message ----- 
From: "Tim Savelle" <tim.savelle at gmail.com>
To: "Farmall/IHC mailing list" <farmall at lists.antique-tractor.com>
Sent: Thursday, June 07, 2012 6:42 AM
Subject: [Farmall] 1949H - Exhaust Pipe - Followup


> Gents, Thanks so much for all of the suggestions.  I really appreciate 
> your
> giving me some different options.  Getting this fixed doesn't seem like as
> daunting a task as it did before.  I can only imagine how much a 2" tap
> would cost.  I like the 2X6" nipple "chaser" suggestion and will give that
> a try first.  If that doesn't work I'll try to find someone with a 2" tap.
> Thanks again! Tim
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
> 


_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall