[AT] Off Topic Goulds piston pump

[charlie hill]

Cecil you aren't butting in at all.  I'll gladly check that out.
You mentioned a pump you had.  Did you check on it?

Charlie

-----Original Message----- 
From: Cecil R Bearden
Sent: Wednesday, June 06, 2012 9:26 AM
To: Antique tractor email discussion group
Subject: Re: [AT] Off Topic Goulds piston pump

Pardon my butting in here, but www.uship.com can get you some really
good rates if you give it a couple of weeks.
Cecil in OKla


On 6/5/2012 5:49 PM, charlie hill wrote:
> Oh and I forgot to say THANKS VERY MUCH BO!
>
> Charlie
>
> -----Original Message-----
> From: Bo Hinch
> Sent: Tuesday, June 05, 2012 6:10 PM
> To: Antique tractor email discussion group
> Subject: Re: [AT] Off Topic Goulds piston pump
>
> Charlie , at this time , I consider it yours . Now the only problem is
> getting it to you . I could make a small shipping palette to mount it on
> and hope it arrives in one piece . What are your suggestions ???
>
> Bo Hinch
>
> On Tue, Jun 5, 2012 at 3:16 PM, charlie hill
> <charliehill at embarqmail.com>wrote:
>
>> Rick,  I don't know how it's plumbed up internally but I'm pretty sure
>> that
>> Schrader valve is for the air charge.  Doesn't matter where it is as air
>> rises above water.  I could be wrong though.
>> I'm not asking you to take yours apart because there is oil in there but
>> you
>> are right.  Just pull the bolts out of the flange behind the flywheel and
>> the crank assembly comes out but I really
>> hate for you to do that.  It's a pain to do it.   Bo and I might be able
>> to
>> work out a deal on the pump he has if we can figure out a deal.
>>
>> Charlie
>>
>> -----Original Message-----
>> From: Richard Strobel
>> Sent: Tuesday, June 05, 2012 1:15 PM
>> To: Antique tractor email discussion group
>> Subject: Re: [AT] Off Topic Goulds piston pump
>>
>> I think you're right Charlie.  I didn't get any pulsations from that port
>> so
>> figgered it was right.  I also tunnel visioned that the Schrader was used
>> for blowing the pump out for winter.  If I were to recharge the
>> Accumulator,
>> I would have put the Schrader on top of the tank.  But anyway, neat stuff
>> and always willing to learn.
>>    I did have it belted up to my 2hp Fairbanks-Morse "Salt block" engine
>> and
>> seemed to do just fine.
>>
>>   Tomorrow I'll take a look at it and see what it takes to get to the 
>> rod.
>> If I remember correctly, a few bolts and it will be out.  I'll keep this
>> conversation in my inbox so I don't forget.
>>
>>    Just remembered, I think I got my sucker leather washers from the man
>> you
>> mentioned earlier.
>>
>> Lots of fun!!
>> Rick
>>
>>
>>
>>
>>
>>
>>
>>
>>
>> ----- Original Message -----
>> From: "charlie hill"<charliehill at embarqmail.com>
>> To: "Antique tractor email discussion group"<at at lists.antique-tractor.com
>> Sent: Tuesday, June 05, 2012 8:13 AM
>> Subject: Re: [AT] Off Topic Goulds piston pump
>>
>>
>>> Rick,  you've been so nice to post your pictures that I hate to be
>>> critical
>>> but let me offer this comment, not
>>> about your pump but on your plumbing.  I believe that you shouldn't have
>>> water exiting the pump from the
>>> hole you show in your "squirting" pictures.  I've thought about how ours
>>> was
>>> at the farm and looked at the
>>> one I have here and also at this video.
>>> http://www.youtube.com/watch?v=9dWh9KdF1PM
>>> I think the video has it right.  The water should exit from the where
>>> you
>>> have a pipe plug in the picture you call
>>> "side view".  The pipe plug below the pressure tank.  The tank should
>>> always
>>> be pressurized. That is why that
>>> Schrader valve is near the bottom of it.  The plug where you have water
>>> "squirting" should either be plugged or
>>> hooked up to a larger pressure tank.  I hope I'm telling you right.
>>> It's
>>> been a long time but looking at the video,
>>> I think he has it right for running without an auxiliary storage tank.
>>>
>>> Charlie
>>>
>>> -----Original Message-----
>>> From: Richard Strobel
>>> Sent: Tuesday, June 05, 2012 8:48 AM
>>> To: Antique tractor email discussion group
>>> Subject: Re: [AT] Off Topic Goulds piston pump
>>>
>>> Here's some other shots I took and uploaded to my webshots:
>>>
>>> http://good-times.webshots.com/album/582918101oBSoRd?vhost=good-times
>>> _______________________________________________
>>> AT mailing list
>>> http://www.antique-tractor.com/mailman/listinfo/at
>>>
>>> _______________________________________________
>>> AT mailing list
>>> http://www.antique-tractor.com/mailman/listinfo/at
>>>
>> _______________________________________________
>> AT mailing list
>> http://www.antique-tractor.com/mailman/listinfo/at
>>
>> _______________________________________________
>> AT mailing list
>> http://www.antique-tractor.com/mailman/listinfo/at
>>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at