[Farmall] No Spark

[Bob Schleyer]

Hi Don; I put a new condenser in and it runs good, It doesn't stall out now
when it's hot. Now it is hard to start when it's hot, tries to start (pops0
but will not catch. When it's cold it starts on the 1st cylinder that fires.
Could it be a bad coil?
Bob 215-768-4502

-----Original Message-----
From: farmall-bounces at lists.antique-tractor.com
[mailto:farmall-bounces at lists.antique-tractor.com] On Behalf Of Don Eicher
Sent: Thursday, July 12, 2012 6:37 PM
To: Farmall/IHC mailing list
Subject: Re: [Farmall] No Spark

Bob....everal things can cause this problem. The most comman is the points
are shorted out,by becoming grounded. There are quite a few other things
that can happen. Call me at 409 659 7547 if you would like to discuss. Don

--- On Thu, 7/12/12, Bob Schleyer <madmapper2 at verizon.net> wrote:


From: Bob Schleyer <madmapper2 at verizon.net>
Subject: [Farmall] No Spark
To: "Farmall/IHC mailing list" <farmall at lists.antique-tractor.com>
Date: Thursday, July 12, 2012, 5:00 PM


I just recently installed new point and condenser in my Cub. It started and
ran good for about an hour of mowing. Then it started to sputter and finally
stopped. Now I have no spark.

Any suggestions?

Thanks

Bob

_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall
_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall