[Farmall] cub steering upgrade

[jtchall at nc.rr.com]

Thanks for the info and confirming it can be done easily. I did some work on 
the front axle several years back--I think it was when we changed the 
engine. I think I put in all new bushings then, can't remember about the 
gearbox. Regardless, the steering should be in great shape, just looking to 
make it better.

John Hall


-----Original Message----- 
From: E. John Puckett
Sent: Sunday, December 16, 2012 3:26 PM
To: Farmall/IHC mailing list
Subject: Re: [Farmall] cub steering upgrade

Here is a link telling a little about my thrust bearing installation
http://www.farmallcub.com/phpBB2/viewtopic.php?f=1&t=58941&hilit=+thrust
On 12/16/2012 7:29 AM, jtchall at nc.rr.com wrote:
> I think someone on the list has done this but I can’t remember. Can you 
> remove the front spindle assemblies from the axle on a Cub and replace the 
> thrust washer at the bottom (I assume there is one there) with a thrust 
> bearing? I can’t remember how the steering arms on the top are located, if 
> it is a bolt/notch type setup then the bearing thickness may be a problem. 
> Anybody here ever tried upgrading this?
> John Hall
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
>
>
>

_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall