[AT] Case diesel

[john hall]

It was running with the fuel spraying out. Working behind the manifold was 
going to be slow so I shut it down to tighten them. Cranked it again using 
penetrating oil and from then on it would crank on its own.

John

----- Original Message ----- 
From: "charlie hill" <charliehill at embarqmail.com>
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Sent: Sunday, April 22, 2012 4:42 PM
Subject: Re: [AT] Case diesel


> John did it pick the fuel up and spray it out around the fittings after it
> fired?  Is it running right now?
>
> Charlie
>
> -----Original Message----- 
> From: john hall
> Sent: Sunday, April 22, 2012 3:45 PM
> To: Antique tractor email discussion group
> Subject: Re: [AT] Case diesel
>
> Got back to the diesel on Sat. I loosened 3 of the fuel lines at the
> injectors, the fourth was too hard to get to due to the exhaust manifold 
> and
> muffler. Tried spinning it over, no fuel. There was a pipe plug in the
> intake so I pulled it out and sprayed penetrating oil in there. After a 
> few
> attempts it fired up, I had left the lines loose. Thanks for the comments
> and suggestions.
> John Hall
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at