[Farmall] 1 point hitches

[Tractorman453657 at aol.com]

It will work providing that you have the rear wheels set narrow. In as far  
as they will go. also you will have to have the draw bar set to the far 
right .  you want the bottom of the moldboard to line up with the inside of the 
rear  tire.It will work just fine.
 
 
In a message dated 9/13/2011 8:44:19 P.M. Eastern Daylight Time,  
dbigdog at columbus.rr.com writes:

Will it  fit? – yes but most likely it will not plow right.  Check this 
link for a  comparison between the two  plows:

http://www.tm-tractor.com/gim/l-f194_-_1-f194_001.htm



From:  Kevin Bish 
Sent: Tuesday, September 13, 2011 8:31 PM
To: Farmall/IHC  mailing list 
Subject: [Farmall] 1 point hitches

I have a 1 point  hitch plow for a Farmall Cub. Will this also fit the 1 
point hitch on a  Farmall 100 tractor??  

_______________________________________________
Farmall mailing  list
http://www.antique-tractor.com/mailman/listinfo/farmall
_______________________________________________
Farmall  mailing  list
http://www.antique-tractor.com/mailman/listinfo/farmall