[Farmall] Need Expert Opinion

[szabelsk at gdls.com]

Jim,

That's were I started trying to figure out what was going on with the 
original wiring that was on the H to start with.

The ignition system was wired with a 12V coil (don't know what kind it was 
other than a Delco, and a really rusty one at that) and an external 
resistor that was in "parallel"  with the coil, not in series. The wire 
from the ignition switch went to the resistor on one side, and from that 
same side, then went to the coil (+). The other end of the resistor was 
grounded through it's mounting bracket. The coil (-) went to the 
distributor. 

Now when I went to replace the coil, I knew I needed a resistor in line to 
drop the voltage. I brought a 6V coil and a new resistor to go with it. I 
didn't realize that the old coil on the H was 12V, and didn't realize how 
the old resistor was wired into it until I took it of and was ready to put 
the 6V coil and new resistor in. 

Since the new coil implies that I don't need an external resistor, I'm 
confused as to whether or not I really need it. If I was putting the 6V 
coil on a 6V tractor, I guess I wouldn't worry about it. But this is a 12V 
tractor.

The Guys at NAPA said that the fact that I had a 6V ignition system 
determined that I needed a 6V coil and didn't need the in-line resistor. 
That's where I disagree with them. I don't think putting a 6V coil in a 
12V system without an in-line resistor is a good idea. That also doesn't 
agree with the fact that the H had a 12V coil to start with.

In your response you only mention three coils

---- 6 volt
---- 12 volt, no resistor required
---- 12 volt, resistor required

Are you saying that there is only one kind of 6V coil? Or are there two, 
one with and one without a resistor required? The new one I have says no 
resistor, but that wouldn't have been the case 50-60 yeas ago would it? 
Aren't the coils that don't need a resistor later/newer technology?

Don't mean to contradict you or anything, just want to make sure I 
understand everything and get things wired up right the first time. I 
really need to have the H up and running this weekend.

Carl Szabelski



This is an e-mail from General Dynamics Land Systems. It is for the intended recipient only and may contain confidential and privileged information.  No one else may read, print, store, copy, forward or act in reliance on it or its attachments.  If you are not the intended recipient, please return this message to the sender and delete the message and any attachments from your computer. Your cooperation is appreciated.