[AT] Allis Chalmers B & C crankshaft

[Recentjester at aol.com]

The B motor crank was .030 under already. The c one is with  the grinder 
guy now hope it makes the cut. 
 
 
In a message dated 5/29/2011 7:50:59 A.M. Central Daylight Time,  
charliehill at embarqmail.com writes:

Not  sure.   AC used a Buda engine in the early B's and then switched to  
an 
AC block.  I can't remember when the change came without looking  it up.  
If 
no one else knows I'll look it up in a while.
If both  are AC blocks I think it will work fine.  The stroke should be the 
 
same.  The B and C used the same engine.   The only  difference would be a 
change that occurred by  year.

Charlie
-----Original Message----- 
From:  Recentjester at aol.com
Sent: Sunday, May 29, 2011 12:57 AM
To:  at at lists.antique-tractor.com
Subject: [AT] Allis Chalmers B & C  crankshaft

Will a c crankshaft work in a B block? the B is 41 an the C  is  48. Is the
stroke the  same?
_______________________________________________
AT mailing  list
http://www.antique-tractor.com/mailman/listinfo/at  

_______________________________________________
AT mailing  list
http://www.antique-tractor.com/mailman/listinfo/at