[AT] .40 main bearings allis B

[Dean VP]

You could do what the unethical engine rebuilders would do back in the 30's
and 40's.  Use the 0.030 under bearings and slip a check blank or two under
each one. :-)

"We are often so caught up in our destination that we forget to appreciate
the journey."
Dean VP
Elma, WA


-----Original Message-----
From: at-bounces at lists.antique-tractor.com
[mailto:at-bounces at lists.antique-tractor.com] On Behalf Of Steve W.
Sent: Sunday, July 10, 2011 7:41 PM
To: Antique tractor email discussion group
Subject: Re: [AT] .40 main bearings allis B

Recentjester at aol.com wrote:
> I am finally rebuilding my Allis B But....they turned the  crank .040 
> under. I need bearings.... didn't see any on the net anybody have a
source?
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>


  Looked through all my catalogs and books, .030 is the largest I've found
for a B.
I have seen complete kits (crank,mains,rods) for $400-600.00 You might want
to look into having it welded up and ground back to standard size.
May be cheaper and it would give you a better chance.

--
Steve W.

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at