[AT] Waaayyyy OT

[Dan Glass]

You can get in the car with the ignition on but everything else off  
with the car in reverse and see which is hot (don't do this without a 
helper).  A few will be hot and holding the meter on each one while the 
car is put in and out of reverse will tell you which one it is.

On 12/31/2011 10:23 AM, Dick Day wrote:
> Thanks. What I actually need is a lead that only becomes energized when the
> car is put into reverse.  The reverse fuse circuit is bundled with several
> other circuits, so unless I can find a lead somewhere under the dash that
> handles just the reverse lights, I'm pretty sure I'll end up running an
> extra line. Not a big deal, was just hoping to avoid running a 12v wire from
> front to back.
>
> Thanks
>
> Dick
>
> --------------------------------------------------
> From: "charlie hill"<charliehill at embarqmail.com>
> Sent: Saturday, December 31, 2011 9:04 AM
> To: "Antique tractor email discussion group"<at at lists.antique-tractor.com>
> Subject: Re: [AT] Waaayyyy OT
>
>> Lots of new vehicles also have fuse boxes in the engine compartment.  You
>> might find an extra accessory socket there if you look around.   Also you
>> could buy a fuse holder and run a wire directly from the battery terminal
>> with the fuse inline near the battery.   What ever you do don't mess with
>> a
>> pink wire unless you want to replace your airbags after they deploy.  For
>> safety sake, disconnect the battery before you do any wiring.
>>
>> Charlie
>>
>> -----Original Message-----
>> From: Dick Day
>> Sent: Friday, December 30, 2011 2:21 PM
>> To: Antique tractor email discussion group
>> Subject: Re: [AT] Waaayyyy OT
>>
>> Dan, thanks. I was hoping that was the case. I'll grab a test light and
>> see.
>> My back just does not take to that awkward bending like it used to.  I
>> wish
>> they could mount those fuse/breaker boxes someplace that was easier to get
>> to ;)
>>
>> Dick
>>
>> --------------------------------------------------
>> From: "Dan Glass"<dglass at numail.org>
>> Sent: Friday, December 30, 2011 5:06 AM
>> To: "Antique tractor email discussion group"
>> <at at lists.antique-tractor.com>
>> Subject: Re: [AT] Waaayyyy OT
>>
>>> I am not sure on this particular vehicle but on most there is a fuse box
>>> under the dash between the steering column and the door.  It should even
>>> be labeled as the back up lights.  That would be a good place to tap in.
>>>
>>> On 12/29/2011 10:13 PM, Dick Day wrote:
>>>> I am about to install a rear-view camera in our '03 Nav.   The
>>>> display/Monitor at the dash has a lead to connect to the reverse light
>>>> in
>>>> the rear of the car. This is what supplies power to the camera when it's
>>>> in
>>>> reverse.
>>>>
>>>> Does anyone know if there is a place at the dash that I could connect to
>>>> for
>>>> this?  Or do I need to run an extra power cable to the rear?
>>>>
>>>> If this goes well, I'll add one to our '06 as well.
>>>>
>>>> This is such a diverse group of people, I am just curious if anyone has
>>>> done
>>>> this before.
>>>>
>>>> Thanks
>>>>
>>>> Dick
>>>>
>>>> _______________________________________________
>>>> AT mailing list
>>>> http://www.antique-tractor.com/mailman/listinfo/at
>>> _______________________________________________
>>> AT mailing list
>>> http://www.antique-tractor.com/mailman/listinfo/at
>>>
>>>
>>> -----
>>> No virus found in this message.
>>> Checked by AVG - www.avg.com
>>> Version: 2012.0.1901 / Virus Database: 2109/4711 - Release Date: 12/29/11
>>>
>> _______________________________________________
>> AT mailing list
>> http://www.antique-tractor.com/mailman/listinfo/at
>>
>> _______________________________________________
>> AT mailing list
>> http://www.antique-tractor.com/mailman/listinfo/at
>>
>>
>> -----
>> No virus found in this message.
>> Checked by AVG - www.avg.com
>> Version: 2012.0.1901 / Virus Database: 2109/4714 - Release Date: 12/31/11
>>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at