[Farmall] Gear Oil

Barney Van De Weert bbvande at yahoo.com
Thu Dec 1 16:18:18 PST 2011


If leaks are an issue, you could use cornhead grease, available at combine Dealers. It could get expensive though. I have been told that it stays in the gearboxes pretty well.
 

Barney Van De Weert


________________________________
From: "farmallgray at aol.com" <farmallgray at aol.com>
To: farmall at lists.antique-tractor.com 
Sent: Thursday, December 1, 2011 10:05 AM
Subject: Re: [Farmall] Gear Oil


They originally used straight SAE 140. It is a little hard to find these days but is still made. It would probably be your best bet to avoid 
leaks from the old felt seals and rope packings.



Todd Markle 

Spring Mills, Pa.



-----Original Message-----
From: Milo <milo at milosmachineshed.com>
To: Farmall/IHC mailing list <farmall at lists.antique-tractor.com>
Sent: Thu, Dec 1, 2011 5:30 am
Subject: [Farmall] Gear Oil


What are you folks using for gear lube in the older units?
'm restoring a 1928 Russell Road Grader that uses a 10-20 (I-20) 
cCormick Deering for power.
'm using the cast iron "tub" from a 1934 10-20, as the original one on 
he grader was broken
t the wheel hub on the right rear.
Also using the bull gear and some of the transmission gears from the 34.
-- 
eace
ilo
ilosmachineshed.com
_______________________________________________
armall mailing list
ttp://www.antique-tractor.com/mailman/listinfo/farmall

_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall



More information about the AT mailing list