[AT] fuel sending unit

[Larry Goss]

LOL!  That's the reason for the vent hole in the first place.  You have to seal it without getting the air hot inside it.

Larry


----- Original Message -----
From: "charlie hill" <charliehill at embarqmail.com>
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Sent: Sunday, August 21, 2011 5:17:58 PM
Subject: Re: [AT] fuel sending unit

John I did well on my first one two but I didn't know to sweat off that 
little dab of solder over the vent hole.  I got the thing back together just 
fine but when it cooled it crushed it's self.

-----Original Message----- 
From: john hall
Sent: Sunday, August 21, 2011 4:13 PM
To: Antique tractor email discussion group
Subject: Re: [AT] fuel sending unit

That was the first time I ever tried to repair a float and it went pretty
quickly. The hard part was finding the crack!

John

----- Original Message ----- 
From: "charlie hill" <charliehill at embarqmail.com>
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Sent: Sunday, August 21, 2011 9:23 AM
Subject: Re: [AT] fuel sending unit


> Try bending the float arm just a bit and see if it helps.
> Did you add any additional solder when you soldered it back up?  Maybe the
> float is heavier now than before.
> My hat's off to you for successfully soldering it up.  Last time I tried
> that I ruined the float.
>
> Charlie
>
>

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at 

_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at