[Farmall] Transmission Oil Change - Wrench Question

[Barney Van De Weert]

I used a large chisel that fit in the plug, then a wrench on the hex shank.
 Barney Van De Weert
3828 Heartwood St
Uniontown OH 44685 


bbvande at yahoo.com
Cell# 330-760-5988 




________________________________
From: "szabelsk at gdls.com" <szabelsk at gdls.com>
To: Farmall/IHC mailing list <farmall at lists.antique-tractor.com>
Sent: Thu, May 27, 2010 11:15:04 AM
Subject: Re: [Farmall] Transmission Oil Change - Wrench Question

Tim,

I know you've gotten a lot of responses to your problem, but I have one 
more that you may want to consider, if you haven't already got the job 
done. 

Why not go to the local hardware store and buy another plug that is male 
(has the square "peg" instead of the square "hole"). Put the "peg" end 
into the oil plug and use a pipe wrench to turn it like an adapter. 

I would imagine that a plug would cost less than an adapter, and you won't 
have to spend time and money making a tool. Wish I had thought of this 
earlier when you first asked.


Carl Szabelski



This is an e-mail from General Dynamics Land Systems. It is for the intended recipient only and may contain confidential and privileged information.  No one else may read, print, store, copy, forward or act in reliance on it or its attachments.  If you are not the intended recipient, please return this message to the sender and delete the message and any attachments from your computer. Your cooperation is appreciated.

_______________________________________________
Farmall mailing list
http://www.antique-tractor.com/mailman/listinfo/farmall