[AT] Farmall H wide front end

[John & Jan Paur]

Very simple.  Just block the tractor, remove the narrow front and install 
the wide one.  The wide front can be installed in two positions.  In the 
rear position, a special plate is neded to bolt the front end to the tractor 
frame.  This plate is not needed when installing in the foreward position. 
You might want to be sure to get this plate when you find/buy the wide 
front.  One other thing, if your tractor has never had a wide front 
installed you may need to drill holes in the tractor frame for some of the 
bolts.  Good luck.  John


----- Original Message ----- 
From: "Bruce Moden" <brucemoden at yahoo.com>
To: "AT Tractor Antique Tractor" <AT at lists.antique-tractor.com>
Sent: Friday, March 26, 2010 3:39 PM
Subject: [AT] Farmall H wide front end


Hey all,

I am redoing a 1940 Farmall H that has a narrow front end that needs work 
(wheels will wobble when you turn hard or hit a bump). I was considering 
replacing the narrow configuration with a wide front end (if I can find 
one). Has anyone out there done one of these with any success?
Thanks,

Pharmr Bruce



_______________________________________________
AT mailing list
http://www.antique-tractor.com/mailman/listinfo/at