[Farmall] 39 A: Crankshaft pulley with setscrew!

[E. John Puckett]

prepare some spacers so the thick part of the hub takes the force, and a 
piece of 1/2 inch threaded rod size of hole  in center of crank). with a 
couple of washers with a little of grease or antiseize on them.  put the 
pulley in boiling water about 20 minutes, and while still hot pull it on 
with a nut on the threaded rod.

szabelsk at gdls.com wrote:
> Same tool I used to pull the pulley of the Cub. The only issue was the 
> timing pin was in the way a little. Wish it worked in reverse for putting 
> the pulley back on!!!!!
>
> Carl Szabelski
>
>
>
> This is an e-mail from General Dynamics Land Systems. It is for the intended recipient only and may contain confidential and privileged information.  No one else may read, print, store, copy, forward or act in reliance on it or its attachments.  If you are not the intended recipient, please return this message to the sender and delete the message and any attachments from your computer. Your cooperation is appreciated.
>
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
>
>
>
>   

-- 
Edgar John Puckett
10142 Mahagony Rd.
Potosi, Mo. 63664
573-438-2799
mobil 573-210-0061