[Farmall] "H" oil filter questions

Robert L. Holtzer rholtzer at earthlink.net
Tue Mar 9 15:12:11 PST 2010


Time and heat are the likely culprits in hardening the gasket.  Even 
if the gasket is pretty hard, the cover will generally seat in my 
experience.  When the cover is tightened a bit, rotate it slightly in 
both directions to improve seating on the gasket.  Actually I would 
do this even with a new gasket.  A new gasket will probably last 
numerous oil changes -- but if a replacement comes with the filter 
each time, why not replace it?  Won't take much effort to replace.

With respect to changing the whole assembly -- why?  Granted it would 
be easier to replace a filter.  On the other hand, it wouldn't look 
'stock' if this is at all important to you.  The CaseIH or NAPA 
filters will do a fine job in the originally configured filter 
system.  Preferably with current detergent oils in my 
preference.  Castrol and Pennzoil are what I've used in my several 
tractors including Farmall.  I know that any number of owners are 
concerned about using detergent oil in old tractors that are a bit 
sludgey.  This has not been my experience but I have changed oil and 
filter within a few hours of changing to detergent.  Also have opened 
up the filters to see how much sludge may have accumulated -- haven't 
found much.  On the other hand if your engine is really sludgey 
(check under valve cover), I'd be cautious.  Farmall thermostats keep 
the engine at a decent operating temperature which should minimize 
sludge build up.

I'm reminded of the philosophical pearl:  "we give nothing more 
freely than our advice".  Happy tractoring!!

Bob Holtzer





At 04:24 AM 3/9/2010, you wrote:
>Pardon me for belaboring this thing, but I'm thinking ahead now....
>
>1. Is it more time between oil changes or is it hours of actual use that
>probably causes the gasket to harden to this degree?
>
>2. If it's age, and I change the oil every few months. should I have to face
>digging the gasket out each time I change the oil?
>
>3. Thinking out of the box....is is possible to change out the entire oil
>filter assembly and replace it with one that will accept a screw-on filter?
>It has been pointed out that the oil filter in this tractor is a
>partial-flow.  Can you get screw-on filters that are compatible with the oil
>pressure and flow of a partial-flow system like this.
>
>Thanks for the patience and help.
>
>Tim
>
>
>On Tue, Mar 9, 2010 at 12:09 AM, Kurt Musgrave <rvar at plainstel.com> wrote:
>
> > Tim, the groove the gasket belongs in is below where you have the gasket
> > sitting in the picture.  I think you will find that the old gasket is still
> > it there, and it will be rock hard and will come out in little bitty chips.
> > You'll need a tiny screwdriver or something, I have a pointed Craftsman awl
> > that works perfect.  After you get the old gasket out the new one will fit
> > very tight in the groove and likely you'll need a blunt object to push it
> > down into the groove especially the last bit of it.
> >
> > _______________________________________________
> > Farmall mailing list
> > http://www.antique-tractor.com/mailman/listinfo/farmall
> >
>_______________________________________________
>Farmall mailing list
>http://www.antique-tractor.com/mailman/listinfo/farmall




More information about the AT mailing list