[Farmall] 39 A: Crankshaft pulley with setscrew!

farmallgray at aol.com farmallgray at aol.com
Sat Mar 6 18:49:26 PST 2010


Have any of you guys ever tried using a harmonic balancer installer to put that pulley back on?
I would think that would be just the ticket since it is made to do the same basic job.
They are pretty reasonable from Harbor Freight.



Todd Markle 

Spring Mills, Pa.



-----Original Message-----
From: E. John Puckett <ejpuckett at centurytel.net>
To: Farmall/IHC mailing list <farmall at lists.antique-tractor.com>
Sent: Sat, Mar 6, 2010 6:26 pm
Subject: Re: [Farmall] 39 A: Crankshaft pulley with setscrew!


prepare some spacers so the thick part of the hub takes the force, and a 
iece of 1/2 inch threaded rod size of hole  in center of crank). with a 
ouple of washers with a little of grease or antiseize on them.  put the 
ulley in boiling water about 20 minutes, and while still hot pull it on 
ith a nut on the threaded rod.
szabelsk at gdls.com wrote:
 Same tool I used to pull the pulley of the Cub. The only issue was the 
 timing pin was in the way a little. Wish it worked in reverse for putting 
 the pulley back on!!!!!

 Carl Szabelski



 This is an e-mail from General Dynamics Land Systems. It is for the intended 
ecipient only and may contain confidential and privileged information.  No one 
lse may read, print, store, copy, forward or act in reliance on it or its 
ttachments.  If you are not the intended recipient, please return this message 
o the sender and delete the message and any attachments from your computer. 
our cooperation is appreciated.

 _______________________________________________
 Farmall mailing list
 http://www.antique-tractor.com/mailman/listinfo/farmall



   
-- 
dgar John Puckett
0142 Mahagony Rd.
otosi, Mo. 63664
73-438-2799
obil 573-210-0061

______________________________________________
armall mailing list
ttp://www.antique-tractor.com/mailman/listinfo/farmall




More information about the AT mailing list