[Farmall] problem?

[cvill]

No clearance at Valve / Rocker arm adjustment, not allowing valve to 
fully close??

Charlie V

farmallgray at aol.com wrote:
> It is possible, but not quite the way you describe it. If the cam isn't timed right, it is possible that the piston could be going up instead of down when the intake valve is open.
>
>
> Todd Markle
> Spring Mills, Pa.
>
>
> -----Original Message-----
> From: Bobby Guilbeau <bguilbea at bellsouth.net>
> To: 'Farmall/IHC mailing list' <farmall at lists.antique-tractor.com>
> Sent: Sat, Sep 5, 2009 7:56 pm
> Subject: [Farmall] problem?
>
>
>
> I think I may have the timing/cam shaft off 180 degrees on a Super AV I am
> restoring.  I have it all put back together to  a point that I am ready to
> run the engine.  The problem that I see no is that when I had crank the
> motor gas is forced out of the carburetor by air pressure.  I think  the
> exhaust stroke is opening up the intake valves instead of the exhaust
> valves.  
>
> With the above scenario is this possible?
>
>
>
> Bobby Guilbeau
> Ranger
> Mountain Bayou Lake Scout Camp
> Evangeline Area Council-Boy Scouts of America
> 337-461-2921
>
>
>
>
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
>
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
> ------------------------------------------------------------------------
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com 
> Version: 8.5.409 / Virus Database: 270.13.71/2333 - Release Date: 08/29/09 06:39:00
>
>