[AT] Case VAC belt pulley

[Gene Dotson]

    The pulley is disengaged by loosening the square bolt ai the mount 
flange and pulling the shaft out to disengage the gear at the base. Then 
lock the bolt to keep it disengaged.

                        Gene



----- Original Message ----- 
From: "Indiana Robinson" <robinson46176 at gmail.com>
To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
Sent: Friday, November 27, 2009 6:39 PM
Subject: [AT] Case VAC belt pulley


>I have the belt pulley for my VAC but it is off. I assume in order to
> allow shifting without it coasting too long. My question is, did Case
> provide a stub shaft guard to keep from getting wrapped up in it when
> the pulley was off?
> I can always make a cap but I thought if Case had put one out
> originally... Well, you guys know...  :-)
>
>
> -- 
> Have you hugged your horses today?
>
> Francis Robinson
> aka "farmer"
> Central Indiana USA
> robinson46176 at gmail.com
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at