[AT] Spam> Tractor engine rebuild stand

Cecil Bearden crbearden at copper.net
Sun Nov 8 03:33:42 PST 2009


I have seen a couple stands built with a slack adjuster from a truck for 
the gear drive   YUou could always chain drive it and use a worm gear 
reduction.  Try SurplusCenter.com for ideas

Cecil in okla

Gene Dotson wrote:
>     Many older grain augers and elevators used a worm drive cable winch to 
> raise and lower them. One could probably be adapted to what you have 
> planned.
> 
>                                 Gene
> 
> 
> 
> 
> 
> ----- Original Message ----- 
> From: "Steve Sewell" <sewell at ohio.edu>
> To: "Antique tractor email discussion group" <at at lists.antique-tractor.com>
> Sent: Saturday, November 07, 2009 11:39 PM
> Subject: [AT] Spam> Tractor engine rebuild stand
> 
> 
>> Looking at stands that can handle 6 cyl. diesel tractor engines. Prices
>> will "floor" you!! )-: Think I'll build one. I have a plan but am missing 
>> a
>> part and don't know where to look. With that much weight I will need gear
>> drive turning. Where does one find a crank ran gear reduction , positive
>> stop - both directions, gear box. That will turn/hold a couple a thousand
>> pounds?
>>
>> -steve
>> _______________________________________________
>> AT mailing list
>> http://www.antique-tractor.com/mailman/listinfo/at 
> 
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
> 



More information about the AT mailing list