[AT] Sawzall blades
charliehill
charliehill at embarqmail.com
Mon Jun 15 15:47:42 PDT 2009
the shop must have better luck with sawzalls than I do.
I always thought demolition blades were kind of coarse and were made to cut
wood, sheet metal, fiberglass and the like. I would think you would need
something with teeth similar to a hacksaw.
How big a hammer was being used to drive out the pin?
It's amazing what a really big hammer will do if you swing it hard enough.
----- Original Message -----
From: "Don Bowen" <don.bowen at earthlink.net>
To: "'Antique tractor email discussion group'"
<at at lists.antique-tractor.com>
Sent: Monday, June 15, 2009 5:52 PM
Subject: [AT] Sawzall blades
>I am looking for recommendations for a good metal cutting blade for a
> Sawzall. When I get back to Missouri in a couple of weeks I have to cut a
> bent pin on a backhoe stabilizer arm. The cylinder needs to come off
> because it has a blown seal and no amount of beating has budged the pin.
> The local shop told him to cut the pin using a Sawzall and what he called
> a
> demolition blade. He was told it would take three or more blades. So
> what
> would be a good blade?
>
>
>
> Don Bowen KI6DIU
>
> New ruralize pages, follow the link off http://www.ruralize.com
>
> http://www.braingarage.com/Dons/Travels/journal/Journal.html
>
>
>
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
More information about the AT
mailing list