[AT] 13/16 - 20 nut

[Larry Goss]

We may have been looking under the wrong category, Kevin.  They may have had them if we had searched under acorn nuts.

Larry


----- Original Message -----
From: oldiron62 at gmail.com
Date: Monday, January 12, 2009 20:31
Subject: Re: [AT] 13/16 - 20 nut
To: Antique tractor email discussion group <at at lists.antique-tractor.com>

> Larry and everyone,  Thanks again  I picked one up 
> today at Oriley auto 
> parts store. Had to buy a kit, still less that 5 bucks. Not as 
> hard to come 
> by as I expected when yall made me aware of what else used that 
> nut. Trailer 
> axles, some older Ford spindles and ?? What I was worried about 
> was the fact 
> that McMaster Carr did not have it or Fastenal either.
> 
> Kevin
> ----- Original Message ----- 
> From: "Larry Goss" <rlgoss at insightbb.com>
> To: "Antique tractor email discussion group" 
> <at at lists.antique-tractor.com>
> Sent: Monday, January 12, 2009 12:26 PM
> Subject: Re: [AT] 13/16 - 20 nut
> 
> 
> >I checked last night.  I don't have that size in the collection.
> >
> > Larry
> >
> >
> > ----- Original Message -----
> > From: oldiron62 at gmail.com
> > Date: Sunday, January 11, 2009 15:03
> > Subject: Re: [AT] 13/16 - 20 nut
> > To: Antique tractor email discussion group 
> <at at lists.antique-tractor.com>
> >
> >> Yes it is an oddball size Larry, if you run accros one. Let me
> >> know I would
> >> like to buy one.
> >> Thanks.
> >>
> >> Kevin
> >> ----- Original Message ----- 
> >> From: "Larry Goss" <rlgoss at insightbb.com>
> >> To: "Antique tractor email discussion group"
> >> <at at lists.antique-tractor.com>
> >> Sent: Sunday, January 11, 2009 1:39 PM
> >> Subject: Re: [AT] 13/16 - 20 nut
> >>
> >>
> >> > What's that supposed to fit, Kevin?  That IS a stange
> >> size.  I might --
> >> > MIGHT have something of that nature in among the galvanized
> >> bolts and nuts
> >> > that I salvaged off the Flint & Walling windmill many years
> >> ago when I was
> >> > restoring it.  All of the threads were oversized because
> >> they were
> >> > galvanized after machining.  Even the wrenchs for those
> >> old windmills were
> >> > special.  They were all oversize to accommodate the zinc
> >> coating that was
> >> > added.  But that's a hefy diameter for use on a windmill.
> >> >
> >> > Larry
> >>
> >> _______________________________________________
> >> AT mailing list
> >> http://www.antique-tractor.com/mailman/listinfo/at
> >>
> > _______________________________________________
> > AT mailing list
> > http://www.antique-tractor.com/mailman/listinfo/at 
> 
> _______________________________________________
> AT mailing list
> http://www.antique-tractor.com/mailman/listinfo/at
>