[Farmall] Drive Shaft For H Lift All

[E. John Puckett]

Carl, I wonder if they would be interested in making a tool for removing 
the screw on drive coupling.  I have one I have not been able to unscrew 
to replace the seal ( the spring that returns the handle to center broke 
and went through the pump years ago, really jammed the couplers on 
tight).  I made one with a lug on an 18 inch handle, but could not budge 
the coupling.  next step is a short one that allows me to get my impact 
wrench on it.

szabelsk at gdls.com wrote:
> ....... I can get one made in our fabrication shop, 
> except that the guys have a tendency to go overboard and bring out their 
> "Six Million Dollar Man"  egos ......."We have the technology, we can make 
> it better than before".  They just love a good challenge and winning 
> bragging rights. Sometimes two or three will compete against each other..........
>
> Carl Szabelski
>
>
>
> This is an e-mail from General Dynamics Land Systems. It is for the intended recipient only and may contain confidential and privileged information.  No one else may read, print, store, copy, forward or act in reliance on it or its attachments.  If you are not the intended recipient, please return this message to the sender and delete the message and any attachments from your computer. Your cooperation is appreciated.
>
> _______________________________________________
> Farmall mailing list
> http://www.antique-tractor.com/mailman/listinfo/farmall
>
>
>
>